Reverse Camera for VW Touareg 2003-2017, Tiguan, Bora 2006 2007, Passat
Automatically display reverse image when you put the gear in the reverse
Replace one of the original license plate lampshade, no need to drill hole
Designed is reference to the original car style, installation is simple and beautiful, totally plug and play
The original Sony CCD chip, clear and stable image
With wide-angle glasses lens, wide viewing angle without dead corner
Using a unique production process, waterproof tight durability
Multiple circuit protection design, stable and reliable quality
How can I install the back up camera?
1. To run the wire to the reverse light wire, the boot panel has to come off. Remember to un clip the rear light at the bottom of the boot panel. 4 x torq screws to be removed. Here are 2, the other 2 are on the opposite site.
2. Then there are are then 12 clips that hold it on.
3. A close up on the clips
4. Make sure you are installing the camera on the correct side. Once you thread the rca plugs through the numberplate hole, they can come out of this hole. Note: I did this by bending a steel clothes hanger into a hook and pulling it through. I would then push the plugs past the hole and use the hook to pull the cable down and and then the plugs out one by one.
5. Once you have the cables out, I looked for the best place to put the receiver on the inside, added some double sided tape and stuck it in to avoid vibration. I then cable tied it to make sure it wouldn't come off in the heat. After soldering in the wires below, I cable tied everything neatly and taped up exposed wires.
The reverse light wires are:
Brown = Negative -
Black Blue = Positive +
Image Sensors | |
SONY CCD lens |
IP rating | IP68 | |
TV System | PAL or NTSC | |
Effective Pixels | 628×582/628×492 | |
Sensing Area(mm) | 4.9×3.7 | |
Resolution(TV Line) | 480 | |
Horizontal Sync Frequency (KHZ) | 15.625/15.734 | |
Vertical Sync Frequency (HZ) | 50/60 | |
Video output | 1Vp-p,75Ohm,RCA male | |
Gamma Consumption | 0.45 | |
AGC | Auto | |
BLC | Auto | |
S/N Ratio | Betterthan 48dB | |
Lens Angle (Deg.) | 170°diagonal | |
Current Consumption (mA) | 200 | |
Power Supply (DCV) | 12V | |
Operating Temperature (Deg.C) | -20~+70(RH95%MAX.) | |
Storage Temperature (Deg.C) | -40~+80(RH95%MAX.) | |
Size | Same as the number plate lampshade of the original car | |
LED lamp | Inside the camera if camera has built-in LED light | |
Current Consumption (mA) | 30~60mA |
Payment Accepted |
![]() |
|
Shipping |
![]() |
|
We offer worldwide shipping service by international couriers like FedEx/UPS/DHL/EMS/Aramex etc., Orders usually be shipped within 1-2 working days and the tracking number will be sent to you by system email. For example, if you come from US, it usually takes about 3-5 business days to arrive your door after place the order. |
Be first to review!
Recommend this product to a friend.
How would you rate this product out of 5 stars?